Home » reverse osmosis
reverse osmosis
View Full Case Study Thorough investigation, application of specialized equipment key to selenium removal. Problem A former coal-fired power plant in the Northeastern U.S. had converted to a natural gas source. However, due to stringent EPA mandates, its remaining coal ash ponds, the byproduct of decades of burning coal, would need to be mitigated. That […]
Read MoreiWWD: Emergency Response Reverse Osmosis & Deionization Trailers
When a Louisiana chemical plant suffered a site-wide blackout, plant personnel learned they would have to bring each power-generation unit, and its corresponding water filtration system, back on-line individually. Facility workers quickly returned the onsite demineralization system to functional status, but it was receiving almost zero condensate return. To re-establish condensate return, which is a […]
Read MoreView Full Case Study Quick rebed turnaround, safety measures satisfy customer. Problem A Midwestern soft drink plant over-pressurized its No. 2 softener tank, damaging the internal tank laterals and rendering the tank useless until it could be repaired. While tank No. 2 was out of service, the customer had to run its production on only […]
Read MoreView Full Case Study Problem Not satisfied with the variable cost of city water and the additional sewer charge associated with disposal of wastewater, managers at a Michigan oil refinery sought to restructure its water system by incorporating reverse osmosis (RO) technology. Plant personnel determined that reusing process wastewater would maximize efficiency and minimize expenses. […]
Read MoreFiltration units deployed for same-day purification
View Full Case Study Problem A Kansas manufacturing plant was forced to shut down after unusually high sodium levels in the Kansas River led to increased salinity in city water. Conductivity of the city water also increased from 500 µS/cm to 1,600 µS/cm. This heightened water conductivity was problematic during the rinsing process as it […]
Read MoreHDPE vs. PVC Piping
View Full White Paper It is no secret that the power sector has changed dramatically over the last 20 years. Stricter government regulations, environmental pressures and tighter budgets have transformed the way energy is produced and consumed, encouraging industry leadership to rethink age-old processes. However, certain industry standards remain constant even though an increased focus […]
Read MoreAutomation simplifies RO replacement energy plant
View Full Case Study Problem Facing the failure of its reverse osmosis systems, an Indiana gas-and-coal energy facility sought the company with the best emergency response and customer service in the industry — MPW Industrial Services. To meet the customer’s standards for this project, MPW would have to execute a quick, efficient setup to provide […]
Read MoreView Full Case Study Problem At a start-up commissioning situation at a power plant in Wyoming, the water balance was out of sync with the assets available to handle it. Therefore, the water level was threatening to breach the pond at this zero liquid discharge site. The water that was to be used when in […]
Read MoreMobile solutions reduce ponds to safe levels
View Full Case Study Problem A North Dakota power plant was not running at full capacity, which caused a water imbalance. This condition led to evaporation pond levels rising to near-overflow conditions. Plant personnel were concerned they could be put in a situation where any overflow would have violated EPA regulations, which could have led […]
Read MoreMPW customizes solution for Canadian chemical manufacturer
View Full Case Study Problem For years, springtime had presented a distinct challenge for a large chemical-production complex in Alberta, Canada. With rain and melting snow, the facility could not handle the resulting high turbidity and TOC (Total Organic Carbon) in its feed water. Because of the elevated TOC levels, the facility was forced to […]
Read More